Blink Outdoor Camera Mount, 360 Degree Adjustable Indoor/Outdoor Wall Mount Bracket for Blink Home Security System Black 3 Pack

It was great, easy to install

They work great once I’ve filed just a small amount at time with my metal finger nail file the little knobs that stick out on the little black rings that goes to your camera it’s just a little black ring, but it has like tiny knobs ONLY filed a little at time until they snapped in place, if you file too much off of it, then it won’t hold it so it’s a little tricky. It would not fit on my older cameras I could’ve bought the old style that were just the short ones, but it doesn’t matter these work good, and they were cheap enough. They do turn very well to get the best angle. I can finally get my other camera back up and have an extra just in case.

The Blink cams come with some cheap, poorly designed plastic mounts and swivels. Easy to break. Blink did it better, offering a larger, steel threaded swivel (after market). Better one shown on top, poor stationary mount shown below. These swivel mounts should be threaded, rather than snap mount. Too bad. It would make it a great security cam. They also made it harder to change batteries. Should be no need to take cam down to replace batteries. Better would be a slide on the side rather than opening the entire case to put in new batteries.

You don’t have to be a handyman to install this device for the cameras. It’s very easy and it just fits. Perfect for the location I needed it for enjoy tinkering.👍👎🧚🏻‍♀️

Much better than the mounts that come with the cameras!

Once you put the clips on the cameras, and then you take them back off later on to change the batteries and the little tabs on the clips break and they don’t want to clip back into the cameras, horrible design on the camera side and manufacturer should come up with a different result They should make them to where you push something in and it pulls the tabs in and then you push it into the camera or release the tab and hold the camera and just pushing them in and snapping them back out horrible design they didn’t give it much thought when they made those

My cameras are a year old. They snap into the original mount. These extension mount are for a screw mount. Very disappointed. Love the cameras, hate the mounts.

One of the cheaper mounting options I found online. It works well. It is not very heavy, just made of light plastic but it does the job. My Blink XT2 cameras snapped right in and they are holding them great. To tighten the screw to lock the camera position is a little finicky, but was able to get the correct angle after a couple of tries. They are holding up great.