Photon Mono M5s Build Plate Flexible Spring Steel Magnetic Build Plate for Resin 3D Printer Anycubic Photon Mono M5/M5s/M5s Pro- SLA 3D Printer Parts/Accessories Build Platform Bed 230x135mm

The plate is of good quality, as is its adhesion to the bed. The magnet holding the plate in place is strong, and you’ll need to apply some force to remove it.It’s easy to clean, and for small prints, it will depend on where on the plate the print is made, as you may sometimes need a spatula to remove it. However, with large prints, it works without any issues.It fits perfectly in my Anycubic Photon Mono M5S Pro!

Poor bed adhesion and failed prints

Flexible build plate for that fits: anycubic photon mono m5s pro 3d resin printer. A must have to make removing your finished print easily.

Expensive and did not magnetize, seemed low quality and had to refund.

So far I'm happy with the flex plate on my M5S. I was having some build plate adhesion issues before but not anymore. Home is now all the way down to the screen, but I think I need to adjust that home position sensor slightly.The main thing that has me concerned is the edges of the plate itself. Its like it was cut and deburred, but that's it. It isn't"sharp", but I am little concerned about it impacting the FEP life. This can be accounted for with some sand paper though

This makes resin printing a lot easier, especially when there are large areas of adhesion that you can flex loose. For smaller prints being able to flex the build plate does not help as much and you still need scrap it off. The other thing the build plate does is go directly in a wash and cure station. If you have enough solution in it you can just put the plate in there and then worry about getting the cleaned prints off the build plate, which can be less messy than trying to get the wet prints off. You may still want to paper towel off the excess resin first to save you solution from getting as dirty. If you do a lot of printing, I recommend getting a second plate so you have a clean one to start a new job with while you clean the other plate and wait for it to dry.

This is a stick-on magnetic build plate upgrade for the Photon M5s. After endless frustration attempting to remove 3d prints using a putty knife as a chisel, I adopted a similar magnetic build plate for my Photon Mono X and it revolutionized the print process, turning it from a nightmare into something that was much more enjoyable. This product does the same for the Photon M5s - I consider these non-optional and am surprised 3D printer manufacturers don't provide them from the factory as a default, given how most people will want access to one on their printer.When affixing this to the printer, be extremely careful to clean off every bit of resin residue from your build plate. Remove the plate from the printer. Use a small bit of IPA, then dry, then wipe with a wet cloth, then dry again. If any remote residue, stickiness or moisture is present, do it again. Have some patience to let it dry before applying the magnet. Then, put a bunch of heavy stuff on top of the plate to squish it against the magnet and let it sit for several hours so the glue sets. A few hours of patience upfront will make a huge difference in preventing failed prints down the line!

The product did not shear to the build plate. The 3m didn’t stick very disappointed.