Pipe Adapter Mount for Starlink Rectangle Dish Adapter Bushing Made for Winegard DS-2000/DS-3000 and for Antennas Direct STM-1000 TV Tower J Mount

Worked really well for me and gives me peace of mind that the upper bracket is not going to go sliding down the tube. could have rigged it cheaper but this is the right way and it works. I used it to mount my Starlink receiver to the top of a flag pole. The mount fit right in the top of the pole hole, (made sure size was right before ordering). The flag pole works well, and gives me the height I need to have no interference. Highly recommend this plug it just secured it a lot better than clamps.

Part does not fit the referenced antenna mount. It is too small in outside diameter.

Easy to put onto the starlink and mount. LOOSE fit for the ds2000 and had no hole that it wants you to screw into. Big let down. There may be other options that are better. This was too loose and very concerning. Made it work but not the happiest with it as I am in high wind and may change it out

Fit was a little loose, did not need any pounding, but a single wrap of electrical tape snugged it right up. Excellent fit with Starlink dish. Made mounting so much easier than some of the other options to attach to a non-starlink mount!

Loose fitting and not secure when inserted into recommended j-pole. Oh and don’t hit it with a mallet or wood block as recommended or it will break. Ugh, Look elsewhere!

I would give this 6 stars if I could! It works perfectly! Utilizes the factory lock and makes for a very sleek look!

These do not fit a standard dish mast properly. They have a loose fit inside pipe. Even with the tiny screw they are loose and will allow starlink to move. Bad Design, I am returning mine since its worthless.

So this is a great adapter if you have had a typical J mount and want to use your Starlink dish with it now. Feed the wire thru the hole in the plug, then down and out of the J mount. Then slide the adapter over your Starlink dish pole, and then push all of it into the top of the J Mount. Comes with a screw to keep the Starlink pole where you want it, and to keep from rotating as well with the wind. (May require a small drilled hole in the J mount).